Underwater pluggable bulkhead connectors: 115V/6.5A, 18AWG, standard series

This series of rubber moulded subsea wet pluggable bulkhead connectors is available with 2, 4, 6 or 8 contacts and a maximum pressure rating of 10,000 psi. The connectors have 18 AWG pigtails and are supplied with aluminium bronze housings as standard. We offer an optional 316 stainless steel housing.

The 2 6.5FBRA, 2 6.5MBRA, 4 6.5FBORA, 4 6.5MBORA, 4 6.5FBORAU and 4 6.5 MBORAU connectors are available in three different thread lengths: 1/2”, 3/4″ and 1”, see product matrix.

Female
Male

Only install with the pigtail on the low pressure side of the bulkhead or vessel. The pigtail-side pressure must not exceed the pressure applied to the connector side.

We stock the range of corresponding 115 volt/6.5 Amp rated cable connectors.

For situations where mated connectors may be under mechanical stress, optional locking sleeves are available to maintain good electrical contact for many but not all connectors – see product matrix. For standard series connectors, the LS series locking sleeve must be fitted to the cable prior to installation.

The subsea connectors use a proven water expulsion mating process achieving ratings of up to 10,000 psi. Electrical power must be off before connecting or separating any of these products.

All dimensions are nominal.

Top